Mercedes-benz U11a600

: Locate the radar sensor behind the front grill or bumper. Unplug the harness connector and check for signs of corrosion. If green buildup is found, clean the pins using electronic contact cleaner, apply dielectric grease, and re-seat the plug. If water has penetrated the interior of the sensor housing, the entire radar unit must be replaced and SCN-coded to the vehicle. 📊 Summary of Diagnostic Actions System Status Recommended Action Scanned via XENTRY / No Dash Lights All driver assists work normally. Ignore the code. It is a known software reporting bug. Dash Lights On / Clean Bumper Cruise and Brake assist disabled.

Based on the profile of Siemens VDO components utilizing this naming convention, the technical profile is estimated as follows: mercedes-benz u11a600

Road grime, ice, or mud covering the front radar (behind the Mercedes star) or rear bumper sensors can break the communication loop. : Locate the radar sensor behind the front grill or bumper

: Clean the front Mercedes emblem or bumper area thoroughly. If the error persists, an independent specialist or dealer must use diagnostic software to check the current sensor angle and perform a dynamic calibration drive to re-align it with the road. 3. Wiring Harness or Water Intrusion If water has penetrated the interior of the