Simrad Rf300 Installation Manual Link

Use the provided rod to connect the RF300 transmitter arm to the rudder tiller arm.

Connect the wires to the dedicated terminals on your Simrad autopilot computer. Refer to your specific autopilot computer manual to confirm terminal labels (typically marked as RUDDER + and RUDDER - ). simrad rf300 installation manual

| Pin | Wire Color | Signal | |-----|------------|------------| | 1 | Shield | Drain | | 2 | Red | +12V DC | | 3 | Black | Ground | | 4 | White | CAN High (H) | | 5 | Blue | CAN Low (L) | Use the provided rod to connect the RF300

: Do not remove the transmitter arm from the unit; it is factory-adjusted and should only be moved via the linkage during installation. Placement : Mount the | Pin | Wire Color | Signal |

The RF300 uses a simple, non-polarized two-wire connection to the Autopilot Computer (labeled as the "RF" terminals).