Elmdene 7422-sfg-g3f Manual !!top!! Jun 2026

The Elmdene 7422-SFG-G3F features a multi-terminal strip. Correctly mapping these connections to your control panel ensures the tamper circuit, strobe, and sounder trigger operate seamlessly. Terminal Label Function Description Connection Destination Permanent Negative Supply Connects to the Panel Auxiliary Negative (0V) Hold Off + (12V) Permanent Positive Supply Connects to the Panel Auxiliary Positive (+12V) Trig - / ENG Negative Sounder Trigger Connects to the Panel Bell Trigger Output (Bell -) Strobe - Negative Strobe Trigger Connects to the Panel Strobe Trigger Output (Strob -) RTN / TAMP Tamper Return Circuit Connects to the Panel Global Tamper / Bell Tamper Input Step-by-Step Installation & Commissioning 1. Pre-Installation Setup

Ensure the rear tamper spring or wall tamper mechanism is compressed flush against the mounting surface. If the surface is uneven, adjust the seating to prevent localized false tamper triggers. Screw the magnet assembly onto the moving door. Step 4: Routing the Cable elmdene 7422-sfg-g3f manual

Connect the module to your control panel. A standard Grade 3 configuration typically uses the following setup: The Elmdene 7422-SFG-G3F features a multi-terminal strip

The (and associated range, often designated as 7422-SFG-G3F, denoting a stainless steel high-grade unit) is a robust, self-powered external sounder engineered for superior performance in commercial and residential security systems. It meets the rigorous demands of EN50131-4 Security Grade 3 standards. 1. Introduction to the Elmdene Rapier G3S (7422-SFG-G3F) Pre-Installation Setup Ensure the rear tamper spring or

Supports a quiet mode for installation and maintenance to avoid triggering the loud siren during testing.