Instruktion för installation av drivrutin för seriell adapter Windows 7 och Windows Vista

Tillbaka »

Instruktionen passar för:

  • Windows 7, 32- och 64-bitars, endast engelsk installationsfil, kan installeras på alla språk av Windows 7.
  • Windows Vista, endast engelsk installationsfil, kan installeras på alla språk av Windows Vista.

Obs! Installera filen innan anslutning av USB<->seriellkabeln i datorn.

Hämta hem installationsfilen genom att klicka på länken här nedan:

UC232A_windows vista_w7_32_64bit.exe »

Mcgs Hmi Touch Calibration Updated -

: Never use sharp objects (like screwdrivers) to calibrate the screen, as this will permanently damage the touch layer. Power Stability

Launch the calibration utility. You will be prompted to tap a series of targets. mcgs hmi touch calibration

This method works even if the touch is completely unresponsive. : Never use sharp objects (like screwdrivers) to

For deeper technical documentation, you can refer to the MCGS TPC7062K Series User Manual . mcgs hmi touch calibration

: Place your finger (or a stylus) anywhere on the screen and keep it pressed .

The HMI is a cornerstone of industrial automation, known for its reliability and user-friendly interface. However, over time or after a system update, you might find that the touch response becomes inaccurate—where you tap a button, but the system registers the touch elsewhere.

mcgs hmi touch calibration

Klicka igång den nedhämtade installationsfilen.

mcgs hmi touch calibration

Installationen startad, första dialogrutan, klicka på Next två gånger.

mcgs hmi touch calibration

Installationen pågår:

mcgs hmi touch calibration

Installationen klar, klicka på Finish Nu skall USB<->seriellkabel anslutas till datorn, i en ledig USB port. Tänk på att denna port bör vara dedikerad och permanent avsedd för denna adapter. Vid byte av USB-port kan adaptern bli tilldelad ett annat COM-portsnummer än det vid första installationen. Låt datorn installera klart adaptern.

mcgs hmi touch calibration

Öppna enhetshanteraren enklast genom att högerklicka på ”Den här datorn” eller ”Dator” och välj ”Hantera”.

mcgs hmi touch calibration

Välj enhetshanteraren:

mcgs hmi touch calibration

Klicka ut enheterna ”Portar och LPT (COM19). Den installerade enheten heter ”ATEN USB to Serial Bridge (COMxx)” Notera numret inom parentesen, denna kan vara olika från klient till klient, beroende på vad som är installerat i klienten sedan tidigare. Detta COM-portsnummer är viktigt för att kunna installera kontrollenheten korrekt.

mcgs hmi touch calibration